Smooth Creasing - Polyloop

thotux · 28th April 2006, 20:35

Smooth creasing was originally advertised in Hex 2 announcements but there is no mention of it in the manual. Anyone figure out how to do it?

schuubars · 28th April 2006, 22:00

Under the Surface modelling Tab try the Smooth Tool, when you use that, you will find the break command.edge_break.jpg

28th April 2006, 20:35	#1 (permalink)
thotux InventionArt Join Date: Apr 2006 Posts: 20	Smooth Creasing Smooth creasing was originally advertised in Hex 2 announcements but there is no mention of it in the manual. Anyone figure out how to do it?

28th April 2006, 22:00	#2 (permalink)
schuubars Spline Join Date: Apr 2006 Location: Switzerland/BL Posts: 52	Under the Surface modelling Tab try the Smooth Tool, when you use that, you will find the break command.edge_break.jpg Attached Thumbnails

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode