Crashing File - Polyloop

moonshot · 15th April 2006, 20:02

Hi all,
I'm experiencing quite a few crashes with hexagon mainly when it comes to smoothed objects. It could be my system (Dell Dimension 9150, Pentium D 920 Viiv, 2 x 512 MB Dual channel, ATI Radeon X600 250MB).
In the attached file, selecting the base of the fin lets my hexagon 1.2 crash. Could some of you check my file if you encounter the same problem? Then I could sort out if the problem is coming from my computer or from hexagon itself.
Regards, Moonshot

DanRoberts · 15th April 2006, 22:12

Hi Moon,

Its not your computer

.... selecting the top part no problems ... selecting the base immediately causes Hex 1.2 to go non-resposive.

It wierd cause its very immediate (its almost like the routine that shows the selection is crashing as it tries to show u what ur selecting).

Looks like a good Bug case to send to Eovia.

Dan

moonshot · 15th April 2006, 23:21

Well thanks Dan,
then I found an easter egg in hex 1.2

. I hope it's gone with hex 2, but i'll report the bug anyway. At least I know now, my machine is ok.

Happy Easter,
Moonshot

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

15th April 2006, 22:12	#2 (permalink)
DanRoberts Nogylop Join Date: Mar 2005 Posts: 100	Hi Moon, Its not your computer .... selecting the top part no problems ... selecting the base immediately causes Hex 1.2 to go non-resposive. It wierd cause its very immediate (its almost like the routine that shows the selection is crashing as it tries to show u what ur selecting). Looks like a good Bug case to send to Eovia. Dan

15th April 2006, 23:21	#3 (permalink)
moonshot Spline Join Date: Feb 2006 Location: Germany Posts: 40	Well thanks Dan, then I found an easter egg in hex 1.2 . I hope it's gone with hex 2, but i'll report the bug anyway. At least I know now, my machine is ok. Happy Easter, Moonshot