Help in hex unfold process!!!! - Polyloop

HyperCube · 11th November 2007, 14:13

Can some one tell me pls, if is possible to save file, in the middle of adding seams, before unfold and keep the seams as they are when u open the file to continue from that point????
I'm a nob in Hex!!!

JakalDesign · 12th November 2007, 07:01

I don't believe so, after the picking of seams and pins you have to validate the operation... so I would assume that it would not be possible.

HyperCube · 12th November 2007, 14:57

The idea is, for example, I want to change some seams or the way is cut, i have all the time to repeat the process of adding seams and pins and finally unfold again ??

JakalDesign · 12th November 2007, 15:17

Yes, you would have to go back and redo your seams and pins. Hexagon does not save the seam and pin information after you unwrap your geometry.

Hep · 25th November 2007, 07:41

Quote:

Originally Posted by HyperCube

Can some one tell me pls, if is possible to save file, in the middle of adding seams, before unfold and keep the seams as they are when u open the file to continue from that point????
I'm a nob in Hex!!!

how do I view these tutorial

11th November 2007, 14:13	#1 (permalink)
HyperCube Vertex Join Date: Nov 2007 Posts: 2	Help in hex unfold process!!!! Can some one tell me pls, if is possible to save file, in the middle of adding seams, before unfold and keep the seams as they are when u open the file to continue from that point???? I'm a nob in Hex!!!

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12th November 2007, 07:01	#2 (permalink)
JakalDesign Extrusion Join Date: Jul 2005 Location: Idaho Falls, ID Posts: 179	I don't believe so, after the picking of seams and pins you have to validate the operation... so I would assume that it would not be possible.

12th November 2007, 14:57	#3 (permalink)
HyperCube Vertex Join Date: Nov 2007 Posts: 2	The idea is, for example, I want to change some seams or the way is cut, i have all the time to repeat the process of adding seams and pins and finally unfold again ??

12th November 2007, 15:17	#4 (permalink)
JakalDesign Extrusion Join Date: Jul 2005 Location: Idaho Falls, ID Posts: 179	Yes, you would have to go back and redo your seams and pins. Hexagon does not save the seam and pin information after you unwrap your geometry.