 |  |  |  |  |  |  | |
| | | ||||||||
| ||||||||||
| ||||||||||
| |||||||
| Modeling - Sculpting Dedicated forum to all the modeling questions & comments, from boxmodeling, edge modeling, assembly of shapes, etc. to sculpting. |
 |
| | LinkBack | Thread Tools | Display Modes |
25th June 2007, 03:47
| #1 (permalink) |
| Dungeon Master  Join Date: Jun 2007 Location: Houston, Texas
Posts: 139
 | Intrude & Loop Cut
I know there is an extrude option in Hex, but is there an intrude? I can get similar results by deleting the faces I dont want, then adjusting the thickness of the result. But that takes too long for me. Also is there a loop cut option? (a loop is selected, object is split into 2 along the selection) I used to use Wings 3d. It had both these features. Then again, Hex has a lot Wings dosen't.
__________________ P()RTAL |
|      |
|
25th June 2007, 21:44
| #2 (permalink) |
| stu   Join Date: Mar 2004
Posts: 909
|
do you mean extrude inwards eric? the extrude tool can do that. no loop cut im afraid ,nearest tool is the extract tool , you need to have the faces selected for that. stu
__________________ just trying to cut down the pain threshold  AMD2.4 dualcore 4 gig ram, 9400GT ,WinXP Home |
|
| |
Linear Mode
