Hi Grendel, I'm new at Hex. and I've managed to get through a few tutes and a lot of the user manual but I'm stuck on the first two steps:
Select points in two loops and arrange them in a
circular pattern using the Universal Manipulator.
Use two points simultaneously to keep it
symmetrical.
and
Then select the polygons for the lens housing.
I selected two points manually then tried the loop tool but nothing happens. I'm not sure what's meant by "use two points simultaneously to keep it symmetrical" So I selected all points on the box manually and tried to understand this:
Quote:
|
Originally Posted by Corndog When you select the surface extrude tool from the above section.. look in the properties window it will then allow you to select the constrained extruder there then all you can do is ectrude along the axis.. I hope this helps and i understood your question.. I had the same problem at first... so many options/ tools to learn. |
Where is the surface extrude tool..I can only find Fast Extrude, Sweep and Extrude. I thought extrude was only to extrude and not tessellate?...so how does an extrude tool create tessellaton?
Maybe you could break the tute down into smaller steps + highlight the tools used pleeeease before I lose what's left of my mind
