Rocket Lad - Polyloop

Grendel · 30th July 2005, 09:56

First time I've tried to build a figure for 3d printing. Modeled in hex about eight hours, posed with skeleton and rendered in C4Pro. Learned alot on this project and had fun.

LUKO · 31st July 2005, 02:03

If this is your first project with Hexagon and Carrara, let me tell you how surprised i am to see the result ! Very good project !

Grendel · 31st July 2005, 07:26

Luko, I've used both before. First time at a human figure and use of bones. The bones gave me a little headache until I figured out vertex weighting.

30th July 2005, 09:56	#1 (permalink)
Grendel Moderator Join Date: Jul 2005 Location: Houston, Texas Posts: 1,262	Rocket Lad First time I've tried to build a figure for 3d printing. Modeled in hex about eight hours, posed with skeleton and rendered in C4Pro. Learned alot on this project and had fun. Attached Thumbnails

31st July 2005, 02:03	#2 (permalink)
LUKO Débutant Join Date: May 2004 Location: Saguenay, Québec, Canada. Posts: 1,921	If this is your first project with Hexagon and Carrara, let me tell you how surprised i am to see the result ! Very good project ! __________________ Dans cet univers provisoire, nos axiomes n'ont qu'une valeur de faits divers : Cioran. Carrara 6 Pro, Amapi Pro 7.52, Hexagon 2.2, Cheetah 4.6, Blender 2.48a. http://blog.iquebec.com/luko-3d

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

31st July 2005, 07:26	#3 (permalink)
Grendel Moderator Join Date: Jul 2005 Location: Houston, Texas Posts: 1,262	Luko, I've used both before. First time at a human figure and use of bones. The bones gave me a little headache until I figured out vertex weighting.