Polyloop - 3D & 2D Forums - View Single Post - Joining a poly & arc to create a new poly

JoeK · 13th October 2007, 00:05

I'm continuing at learning Amapi by trying to create a lamp standard.

A lamp standard is straight with a curved section at the top. For this particular model, the vertical straight is 5 meters, with a 2.5m radius at 90 degrees on top of that.

I created a poly straight line, and then created a 2.5m arc and joined the edge of the arc to the top of the poly - therefore creating the profile for the lamp standard.

In order for me to extrude the lamp shape, I have to join the poly and the arc into a single, continuous polyline. Somehow, I managed to do this in AMAPI 6, but can't figure out a way in Amapi 7.52.

Any suggestions? Tx.

13th October 2007, 00:05	#1 (permalink)
JoeK Vertex Join Date: May 2005 Location: Ruskin, BC, Canada Posts: 28	Joining a poly & arc to create a new poly I'm continuing at learning Amapi by trying to create a lamp standard. A lamp standard is straight with a curved section at the top. For this particular model, the vertical straight is 5 meters, with a 2.5m radius at 90 degrees on top of that. I created a poly straight line, and then created a 2.5m arc and joined the edge of the arc to the top of the poly - therefore creating the profile for the lamp standard. In order for me to extrude the lamp shape, I have to join the poly and the arc into a single, continuous polyline. Somehow, I managed to do this in AMAPI 6, but can't figure out a way in Amapi 7.52. Any suggestions? Tx. Attached Thumbnails